Summary

Kenneth Honea Early Man Projectile Points in the Southwest

It is a curious fact that Early Southwestern Man most often made his tools of very finely textured stone. Perhaps this custom was induced by the exacting, finely controlled technologies of stone flaking practiced and the kinds of tools made. Indeed, workmanship on many projectile points, knives, and scrapers is so well achieved that one is led to believe that Early Man strove to express some degree of esthetic idealism in his tools.
Source: Gutenberg

Kenneth Honea Early Man Projectile Points in the Southwest

Browns Valley points are broad lanceolate in shape. Upper lateral edges are slightly rounded. Lower lateral edges are much less rounded, contracting very slightly to either a shallowly concave or straight base. These points are broadest at mid-section. 17 Dimensions are: length 7.0 to 8.0 cm., width 3.0 cm. (full range indeterminate since few specimens known) . Workmanship is fine. Initial shaping may have been by direct or indirect percussion. The initial flake scars are parallel and run obliquely across the point faces; less often they are at right angles.
Source: Gutenberg

Kenneth Honea Early Man Projectile Points in the Southwest

Instead of tapering to a rounded base, the straight-edged stem of Sandia II points contracts to a straight or slightly concave base. Workmanship is 6 generally finer than in the other type, though achieved by the same means. Resolved secondary edge thinning is noticeable on many specimens. Sandia II points are also marked by vertical basal thinning, produced by the removal of a large, or several smaller longish flakes parallel to the point long-axis, anticipating perhaps the fluting found on Clovis and Folsom points. Vertical basal thinning is absent on points of the Sandia I type.
Source: Gutenberg

Get perspective with Kwize: daily news enlightened by great literature