Gerard Fowke

“ The articles known as paint stones scarcely come under the head of implements. Some of the hematite pieces are incipient celts, hemispheres, or cones; but most of them were used merely to furnish paint, at any rate until rubbed down quite small. They are of every degree of firmness, some being as brittle as dry clay, others like iron. Most pieces in the collection are from Kanawha valley, but others are from southeastern Tennessee, northeastern Arkansas, and Caldwell county, North Carolina. ”

“ Chisels and Scrapers.
The aboriginal implements known as “chisels” are round, elliptical, or rectangular in section. The flint and jasper specimens are generally widest at the edge, the reverse being usually the case with those of other material. Most of them have marks of hammers at the blunt end, though some are polished at the top and a few, from eastern Tennessee, are sharp at both ends. The top (except in the double-edged ones) is usually flat, though a few are pointed or very thin, almost with cutting edges. Jaspers and flints are chipped, with the facets polished, the edges highly so. ”

“ An apparent medium between the two is sometimes seen, in which there is a projection on the lower side of the groove only; this is due, usually, to dressing the blade down thinner after the implement was originally worked to a symmetric outline. By continuous or long use the edge of the ax becomes broken or blunted and requires sharpening, and in order to keep the proper outline to make the tool efficient, it is necessary to work the blade thinner as it becomes shorter. No such change is required in the poll, consequently a projection is formed where originally there was no trace of one. ”

“ All the flakes in the Bureau collection are small, few of them being over three inches long. They are found elsewhere with a length of over a foot; but the nature of the flint occurring in the United States is seldom such as to allow flakes to be struck off equaling in size those found in Europe.
Evans says that blows with a pebble will form just such flakes as those produced by an iron hammer; the blows must, however, be delivered in exactly the right spot and with the proper force. Cores sometimes show markings of hammers when struck too near the edge. ”

“ The edge may be straight or curved, and is usually chipped, though sometimes ground; a few are chisel-shaped. Usually they show no signs of wear; when they do, it is always in the form of a polish at the larger end, or on the exposed facets. One of black flint, 8 inches long, from Kanawha valley, has a scraper-form edge, smoothly polished. Many, even of those scarcely changed from their original form and natural surface, have the edges dulled and polished from use as scrapers or adzes. ”

“ Partly finished specimens show that the groove was pecked out and the edge ground before the remaining parts of the ax were worked. Some have the edge ground sharp and the groove worn smooth or even polished by long use, while all the rest of the implement retains the original weathered surface. A stone was always chosen that could be brought to the desired form with the least labor, and very often one could be found that required but little work to make a very satisfactory weapon or implement or even ornament. ”

“ Cavity a regular curve from side to side. The type (figure 95) is of quartz, from Cherokee county, Georgia. There are also, from Kanawha valley, West Virginia, one of sandstone, of which one side has been worked out by a flint, the little pits being distinctly visible, while the other side has natural surface; from Loudon county, Tennessee, one of 101 quartzite, 6 inches diameter, which has been used as a mortar, the cavities being roughened, with their edges broken and scarred (the edge of the stone is battered entirely around midway between the sides as though used for a hammer) ”

“ It is more probable that drilling was done with a stick or horn, with sand as a cutting medium, except in the thin tablets of slate or similar stone and in shells. The thicker flints would answer very well for this purpose, and the countersunk holes appear to indicate such an instrument. For sewing, bone would be more easily worked, and better suited than flint. The double-pointed slender specimens may have been used for bait-holders in fishing; bone implements of a similar shape, with a hole drilled at the middle for attaching a line, have been seen in use among the Indians of Florida. ”

“ When, however, their full value has been given to the differences in the productions of the Ground Stone Age, there remains a residue of a most remarkable kind. In the first place, a very small number of classes, flakes, knives, scrapers, spear and arrow heads, celts, and hammers take in the great mass of specimens in museums; and in the second place, the prevailing character of these implements, whether modern or thousands of years old, whether found on this side of the world or on the other, is a marked uniformity. ”

“ Figure 101 (chalcedony, from a mound in Monroe county, Tennessee) represents the type. The material is variable.
D. Like the last, except much smaller. Very few are polished over the entire surface; some are rubbed more or less on the edges or sides, but a majority have the edge rough as it was chipped or pecked out; many have either the edge or sides in the natural state. From those smoothly polished to those very rudely worked the gradation is such that no dividing line can be drawn. This is true, also, of the smaller specimens of other types. ”

“ Figure 122 represents a piece of smoothly dressed steatite from Desha county, Arkansas, with a two-thirds round section, the ends rounded, with a groove near one end, which may be classed with the plummets. There are pieces of sandstone from the same locality which connect this pattern with the simpler “boat-form” stones, except that the flat side is ground smooth instead of being hollowed. This is only one of numerous examples where the shapes of implements whose “typical forms” seem utterly dissimilar merge into one another so gradually that no line of demarkation can be drawn. ”

“ Careful study of the entire collection has failed to show the slightest difference in the form, finish, or material of implements from the same locality, whether found in mounds or graves or on the surface; hence no attempt is made to separate the two classes of objects. Allowance is to be made for the weathering of a surface specimen, but this is the only distinction.
It is not always easy to identify a stone, even with a fresh surface; in a weathered specimen it is often impossible. ”

“ Occasionally specimens indicate by the manner of wear their application to certain kinds of work. Sometimes the edge is curved by the wearing away of one face until it has almost a gouge form; sometimes the side of the blade next the hand, again that farthest away, is more worn. This in time would give the blunt-pointed edge. A peculiar finish of the lower part of the blade, which is also seen in a few celts, is shown in figure 42, of sienite, from Carter county, Tennessee. One half of each face has been left full, and the part opposite hollowed out, giving an ogee curve to the edge. ”

“ The collection of the Bureau of Ethnology includes almost every type of stone implement or ornament, and as the investigations and explorations of the collaborators have extended over nearly all the eastern and central portions of the Mississippi valley, it furnishes a substantial basis for showing the geographic distribution of various forms of objects in use among the aboriginal inhabitants. ”

“ Many, if not a majority, of the entire-grooved axes have the groove wide enough for a very large handle, or for an ordinary withe to be twisted twice around. In those which have one side ungrooved, the intention was to admit a wedge between the stone and the curve of the handle. The handles were very firmly fastened; two axes in the collection have been broken in such a way that on one side, from the top half way down, the blade is gone, carrying away the groove on that side ”

“ Some of the finer grades, as chalcedony and quartz, that have received the highest finish, appear to have had all the work done by grinding or rubbing, as even those only slightly worked bear no signs of hammering or pecking. When of the harder materials they are generally made of water-worn pebbles as nearly the desired form as can be found; in fact, some specimens which are in their natural state, entirely unworked, require a very close examination to distinguish them from others whose whole surface has been artificially produced. ”

“ The various Indians of Guiana in their leisure hours often fashion highly ornamental weapons and implements which they never use except ceremonially, but keep proudly at home for show.91
So, too, the Yurok and Hupa Indians of California, as well as some of the tribes of Oregon, have very large spearheads or knives, which are not designed for use, but only to be produced on the occasion of a great dance. The larger weapons are wrapped in skin to protect the hand; the smaller ones are glued to a handle. ”

“ Those from Miami valley, and one from Kanawha valley are much longer than the others. The type illustrated in figure 88 is of quartzite, from McMinn county, Tennessee.
Pitted Stones.
There is scarcely a locality in the country where pitted stones are not found; they are indeed of such frequent occurrence that they are seldom considered worth the trouble of gathering.
There can be no “type” among such crude implements; they are almost invariably waterworn sandstone pebbles, with a pit varying from a slight roughening of the surface to a hollow half an inch in depth pecked in each face. ”

“ The Klamath Indians, according to Schumacher, have a slender stick 11⁄2 feet long, with a piece of sea-lion tooth, or antler, fastened to the end of it. Holding one end under the arm to steady it, they take a flake in the left hand, wrapped in a piece of buckskin so as to leave only the edge exposed, and by pressure with the point of the tool break off flakes as large as necessary, the last being quite fine, to give sharp edges to the arrow. ”

“ The Senecas and Cayugas are said by Morgan to have used wooden mortars in which to pound corn after it was hulled,42 and it is possible that the long pestles of soft stone were used with wooden mortars, though some are not well adapted to this use. The Iroquois women pounded in stone mortars the stony material used in tempering the clay for their pottery.43 The California Indians made mortars by knocking a segment off a bowlder, making a flat surface, and working out with a hammer and chisel,44 while the tribes of the interior worked directly from the surface of a suitable rock. ”

“ All such specimens in the collection, except one, are from Kanawha valley, and of hematite; many if not most of them have been ground down from the nodule, and were probably paint stones originally; at least, the material rubbed from them was used as paint while the maker had their final form in view. One, however, has been pecked into shape and is entirely without polish. In all, the base is flat and varies in outline from almost a circle to a narrow ellipse. A section of the stone parallel to either axis of the base varies from a little more to a little less than a semicircle. ”

“ According to Evans, the Mexican Indians take a piece of obsidian in the left hand and press it firmly against the point of a small goathorn held in the right, and by moving it gently in different directions they chip off small flakes until the arrow is complete;136 they also 140 cut a notch in the end of a bone, into which the edge of the flake is inserted and a chip broken off by a sideways blow.137 According to the same author, the Eskimo sometimes set the flake in a piece of split wood. ”

“ The longer ones can be readily grasped in the hand, and are as well adapted to stripping off the hide of an animal, dividing the skeleton at the joints, or stripping the flesh from the bones, as anything made of stone can be; while the smaller ones, set in a handle to afford a grip, would answer the same purpose. ”

“ These implements were probably used as knives or scrapers, being set into the end of a piece of antler, which may in turn have been set into a larger handle of wood. That some were knives is shown by the edge which is dulled to a flat polished surface extending from side to side; and that many were scrapers is shown by their celt-scraper shape, a half elliptical section, or by the scraper-form edge, seen in the largest specimen. Some, however, have the edge symmetrical, as in the hatchet-celts. One has incurved sides, and is roughened on the sides and on the faces near the top. ”

“ Stones evidently used for grinding and polishing need only to be mentioned, as they are of widespread occurrence. Implements used for the 94 former purpose are made of any siliceous stone of convenient size and suitable texture, from a coarse quartzite to a very fine close-grained sandstone, according to the class of work to be done. The markings on them range from the narrow, sharp, incised lines due to shaping a small ornament, to the broad grooves resulting from grinding an ax or celt into form. Nearly all of those in museums are small specimens used for rubbing ”

“ The state of things among the lower tribes which presents itself to the student is a substantial similarity in knowledge, arts, and customs, running through the whole world. Not that the whole culture of all tribes is alike—far from it ”

“ There is also a similar adze from Saline county, Arkansas. All the specimens of this class are of argillite. 71
With the grooved axes is also placed a class of implements that may be called axes notched on the sides. Many of them were no doubt used as sinkers; but some of the same form, size, and material have the notches and sometimes portions of the face worn perfectly smooth, while frequently they are ground to a sharp edge. Again, even in those that have not the least polish, the edge shows marks that would seem to result from use as axes, adzes, or hoes. ”

“ From the smooth, symmetrical, highly-polished chungke stone they gradually merge into mullers, pestles, pitted stones, polishers, hammers,80 ornaments, and 100 the ordinary sinker or club-head, so that no dividing line is possible. Theories constructed on a basis of their use may be far from correct.
They present various forms and degrees of finish; many have the natural surface on both sides with the edge worked off by grinding or pecking, the latter being produced probably by use as a hammer; the sides may be ground down while the edge remains untouched ”

“ The stemmed implements may be barbed or not, and the stem either narrower or broader toward the end.
The name “arrowhead” so commonly applied, fits only the minority of specimens, as none but the smaller ones could be so used; the larger are too heavy. The longest stone arrowpoint in the extensive collection of arrows in the National Museum measures two and five-eighths inches in length and is narrow and thin. An arrowpoint two inches in length is seldom seen. The larger specimens were probably knives and spearheads ”

“ E. B. Tylor, the flint arrows of the Dakota, the Apache, or the Comanche might easily be mistaken for the weapons dug up on the banks of the Thames;1 while cores of flint in Scandinavia and of obsidian in Mexico are exactly alike,2 and a tray filled with European arrowheads can not be distinguished from a tray of American ones.3 Prof. Otis T. Mason observes that the great variety of form in such weapons after they are finished is due partly to nature and partly to the workman’s desire to produce a certain kind of implement. ”

“ Frequently the large flat spalls knocked from blocks or chunks of flint in shaping them, or in obtaining pieces to work, are of such form that very little additional labor converts them into serviceable scrapers, knives, spears, or arrows. A number of such pieces are found in the collection. These, however, are not considered in the flakes now to be described:
A. Edges bluntly chipped (from the concave side) for use as scrapers. They may or may not have notches for attachment to a handle. ”

“ Small triangular or oval arrowpoints, differing from those previously described in being too small for any similar uses, few of them 148 being so much as two inches in length, and varying from that size to not more than half an inch. Nearly all are very thin, though some of the narrower ones may have a diamond or thick lenticular section. Some are very slender, so much so that they are usually classed as perforators; others are equilateral. Both the base and edges may be straight, convex, or concave. A few have a shallow notch in each edge just above the corner ”