National Institute for Occupational Safety and Health

Summary

National Institute for Occupational Safety and Health NIOSH Manual of Analytical Methods… (1994)

All work should be performed with adequate ventilation for personnel and equipment. It is imperative that acid be added to water in order to avoid a violent exothermic reaction. There is risk of fire and explosion when phosphoric acid has contact with bases, combustible substances, oxidizing agents, reducing agents or water. Avoid physical contact since both sulfuric and phosphoric acid are both corrosive and irritants to eyes, skin, and the respiratory system.
Source: Wikisource

National Institute for Occupational Safety and Health NIOSH Manual of Analytical Methods… (1994)

Particulate salts of sulfate or phosphate will give a positive interference. OTHER METHODS: This procedure, which is consistent with ISO 21438-1 [6] , replaces NIOSH 7903 [8] for the determination of sulfuric and phosphoric acid in workplace air samples by IC. The main advantage of NIOSH method 7908 is that it can allow for the collection of the inhalable fraction of sulfuric and phosphoric acid aerosols by means of the pre-filter (housed within an optional inhalable sampler.)
Source: Wikisource

National Institute for Occupational Safety and Health NIOSH Manual of Analytical Methods… (1994)

V = volume, in mL, of the sample test solutions 1 Fd = dilution factor for each sample test solution Fc = conversion factor to convert from anion to acid concentration: Fc = 1.021 for sulfate; Fc = 1.031 for phosphate EVALUATION OF METHOD: Laboratory testing with generated atmospheres of sulfuric acid mist yielded a collection efficiency of greater than 95% over the range 0.5 to 10 mg/m3 of H2SO4 on 0.45 μm pore size PTFE filters [4] . Greater than 95% recovery of sulfuric acid and phosphoric acid was found four weeks after sample collection.
Source: Wikisource

Get perspective with Kwize: daily news enlightened by great literature