Pneumatic tube

“ It gives a smooth and accurate tube. It can be made in most convenient lengths. It is strong and not easily deformed. The bell-joint, calked with lead and oakum, having the tubes fitted together male and female at the bottom of the bell, is the best joint yet devised for pneumatic tubes. It is slightly yielding, accommodating itself to slight changes of length of tube due to changes of temperature, and it allows slight bends to be made at each joint. The joints are very accurate, presenting no shoulders to obstruct the passage of carriers. ”

“ Usually the basement of a building would have to be utilized for the termination of such a tube. There are but few places in our large cities where the streets are so free from pipes, sewers, conduits, etc., that it would be practicable to build a thirty-six-inch pneumatic tube. When the service can be rendered by an eight-inch tube, the cost of installation favors its adoption. ”

“ The air flows nearly as rapidly when a carrier is in the tube as when there is none. The friction of the carrier against the inner surface of the tube creates a slight drag, but it checks the speed of the air only a little. Therefore, in order to know the speed with which a carrier will be transported from one station to another through a pneumatic tube, we need only to know the velocity with which the air flows through the tube when no carrier is present. ”

“ Again, when compressed air is used, we have a larger difference in pressure between the pressure in the tube and the atmosphere to operate our mechanism by cylinders and pistons. With an exhaust system carriers are not so easily ejected from the tubes of the receiving apparatus; we could not use the simple form of open receiver. Again, if the tubes are laid in wet ground, and a leak occurs in any of the joints, water will be drawn in if air is being exhausted from the tube, while it will be kept out if compressed air is used. ”

“ The currents of air entering and leaving the tubes are not so strong as to cause any special annoyance. At the cashier’s desk some simple receiving and sending apparatus has to be used, but it is better to concentrate all of the apparatus at one point rather than have it distributed about the store, as would be the case if the double system were not used. In the London pneumatic telegraph both methods of operation have been in use. Double lines were laid, and the engines exhausted the air from one tube and forced it into the other. ”

“ The nose of the carrier is usually fitted with a felt “buffer” which also assists in making an air-tight fit. A carrier for a 21⁄2 in. tube is 63⁄4 ins. long and weighs empty about 3 ozs. Fig. 26 shows a large carrier.
Methods of Working. Pneumatic tubes are worked either by air above atmospheric pressure or by reducing the pressure below atmospheric. In the pressure system the usual pressure is about 10 lbs. per sq. in. above atmospheric pressure, whilst in the suction system the vacuum employed is equivalent to about 61⁄2 lbs. ”

“ The modern human messenger is so poor a counterpart of the god, and his feet are so far from being winged, that for certain purposes we have fallen back on elemental air-currents, not unrestrained like the breezes, but confined to the narrow and certain paths of the metal tube.
The pneumatic despatch, which at the present day is by no means universal, has been tried in various forms for several decades. Its first public installation dates from 1853, when a tube three inches in diameter and 220 yards long was laid in London to connect the International Telegraph Company with the Stock Exchange. ”

“ Experience shows that, where great exactness of manipulation cannot be obtained, it is necessary to allow only one train in each section of a tube, whether worked by vacuum or pressure. But where there is no intermediate station, and where the tube can be carefully worked, carriers may be allowed to follow one another at short intervals in a tube worked by vacuum, although it is not perfectly safe to do so in one worked by pressure. ”

“ When the air is exhausted from the tube, we are using a current of rarefied air, and this moves through the tube with less friction and, consequently, a higher velocity, for the same difference of pressure, than the more dense compressed air. But for short tubes that require only a small difference of pressure, this advantage becomes very small, and is overbalanced by other advantages of a compressed air system. So, taking141 everything into consideration, there is not so much to be said in favor of an exhaust system. ”

“ Where the ground is firm, no other support is needed for the tubes than to tamp the earth solidly about them. In order to economize space in the streets, it is customary to lay the tubes one above the other; and it is very convenient, although not necessary, to separate them by cast-iron saddle brackets. Such an arrangement has to be frequently departed from in order to overcome obstructions in the streets and to get through narrow passages. At all low points in a tube line, traps are provided to catch any moisture that may accumulate. ”

“ While the Pneumatic Transit Company has ample field in the State of Pennsylvania to carry out the work which it has mapped out, a field broad enough to yield a good profit for the capital invested, there is no reason why the system should be limited to one State. So, in order to obtain a broader charter, covering all places where pneumatic service may be needed, a new corporation was formed and styled the Batcheller Pneumatic Tube Company.
It is impossible to lay down a rigid system equally well58 adapted to all places and purposes. We must accommodate ourselves somewhat to circumstances. ”

“ This is applicable to the water closet refuse alone. The pneumatic system acts as follows: A large air-tight cylinder on wheels, or, what answers equally, a series of air-tight barrels connected together by tubes about 3 in. diameter, placed on a cart, brought as near to the cesspit as is convenient; a tube of about the same diameter is led from them to the cesspit; the air is then exhausted in the barrels or cylinder either by means of an air pump or by means of steam injected into it, which, on condensation, forms a vacuum ”

“ The two systems are sometimes distinguished by calling one a pressure system and the other an exhaust system. These terms are very misleading, for an exhaust system is a pressure system. The current of air is kept flowing in a tube by maintaining a difference of pressure at the two ends, and the result is the same whether we raise the pressure at one end above the atmospheric or lower it at the other below the atmospheric. ”

“ It acts by the reflection of sound-waves on a rubber diaphragm. A small metal disk is cemented to the rubber, and above this is a pointed screw, D. An electric circuit is closed where the points C and D are brought in contact. To locate an obstruction a pistol is fired into the tube as shown, and the resulting wave, traversing the tube at the rate of three hundred and thirty metres a second, strikes the obstruction and is then reflected against the diaphragm, which in its turn reflects it to the obstacle, whence it returns to the diaphragm. ”

“ At curves a guard-rail is placed upon the side wall, making it impossible for a carrier to leave the track. The carriers are made of hard wood with an iron frame, and are as light as consistent with the service required of them. They are open on top. Their outside dimensions are thirty-four inches by thirty-four inches by eight feet. The sending and receiving apparatus for these very large tubes have to be specially designed for each particular station, so no attempt will be made here to describe them. The air-pressure required depends upon the length of the line. ”

“ If the valves are not large enough or do not open promptly, our cylinders will not be filled with air at each stroke; this will reduce the efficiency of the machine. In practice we go to a manufacturer of air-compressors and tell him how much air must be compressed per minute, and the pressure to which it must be compressed,137 with other conditions, and then he tells us what size of machine we shall require and the horse-power of the machine approximately. ”

“ Horse-Power.—Having shown how the quantity of air can be computed we are now in a position to estimate the horse-power of the air-compressor necessary to operate the tube. I say estimate, because we have to take into consideration the efficiency of the air-compressor, and that is not an absolutely fixed quantity: it varies with different types of machines and with their construction. When working with pressures of less than ten pounds, the friction of the machine is an important factor. ”

“ The tubes of the Paris system are of wrought iron, in lengths of from fifteen to twenty feet, the joints being made with flanges and bolts. The interior diameter is 2.559 inches with a maximum variation to 2.519 inches. The bends are made with a radius of from six to one hundred and fifty feet. Water frequently gives trouble by accumulating in the tubes. Traps are placed at low points to drain it off. ”

“ If poppet valves are used in the air-cylinders, and they are most common, the speed in revolutions per minute should not be high. Duplex are better than single cylinder compressors, because they deliver the air in a more steady stream,—the pulsations are less. For constant running, economy of steam is an important item; therefore some good type of cut-off valve should be provided. The air-cylinders should not be water-jacketed unless the pressure is above twenty-five pounds per square inch. It is better to use the air as warm as possible, for it will soon be cooled after entering the tube. ”

“ The platform, K, is connected by rods, bell-cranks, etc., to the piston slide-valve, so that when it swings downward by the weight of a carrier, the slide-valve is moved upward into its normal position, and this causes the receiving chamber to tilt back into a horizontal position ready to receive the next carrier. The time that elapses from the arrival of a carrier until the receiving chamber has returned to its horizontal position is not more than three or four seconds. Nothing could operate in a more satisfactory manner. ”

“ In working by pressure it has been found that, notwithstanding a fair interval may be allowed, carriers are apt to overtake one another, for no two carriers travel in the same times, because of differences in fit, unless they are placed end to end. If signalling be neglected and a carrier happens to stick fast, being followed by several others, a block will ensue which it will be difficult to clear, while the single carrier could readily have been dislodged. ”

“ It is very natural to ask the question, why are tubes sometimes operated by compressing the air and at other times by exhausting it? We answer by saying that it is usually a question of simplicity and convenience that determines which system shall be used. ”

“ To the right of the speakwrite, a small pneumatic tube for written messages, to the left, a larger one for newspapers; and in the side wall, within easy reach of Winston’s arm, a large oblong slit protected by a wire grating. ”

“ Aim and Object of the Company.—When the Pneumatic Transit Company was formed, it was the aim and object of its promoters to construct an extensive system of underground tubes in the City of Philadelphia which would serve, first, for the rapid transmission of mail, second, for the quick delivery of merchandise from the large retail stores, third, for the transmission of telegrams or messages within the city limits, and, fourth, to conduct a general local express business with greater speed than can be done in any other manner. ”

“ It would be very difficult to bend iron tubes without involving great expense. The thickness of the bent portion of an eight-inch tube is usually three-sixteenths of an inch and never less than one-eighth of an inch. ”