Faucet

Definition and stakes

George M. Warren,  Simple Plumbing Repairs in the Home

“ A good plumber, before screwing up a piece of pipe, always stands the pipe on end and raps it with a hammer to clear the bore.
Figure 4, A, shows an ordinary half-inch lever-handle Fuller faucet which closes with the pressure. As shown in figure 4, B, the bottom of the spindle is eccentric, so that slight turning of the handle moves the rubber ball to and from the beveled seat. To replace the ball shut off the water to the faucet. Unscrew the body from the tailpiece with the hands or with a monkey wrench on the hexagonal part of the body of the faucet.
”
Source: Gutenberg

Ralph Bergengren,  The Comforts of Home

“ Then I monkey a little with the washer (still making those queer animal noises) , put on the faucet, run down cellar, turn on the water, run up from the cellar, and look at the faucet. Sooner or later the faucet always stops leaking. It is a mere matter of adjusting the washer; any handy man can do it with a little patience.
Winter in the country is the time and place to get acquainted with the plumber.
”
Source: Gutenberg

Portrait of Friedrich Christian Accum Friedrich Christian Accum,  A Practical Treatise on Gas-light

“ The inner parts of the faucet ought to be no larger in diameter than just to fit the spigot. This supports the pipe, independently of the cement, and prevents the risk of hurting the joint from any external stress. The inner faucet is commonly made about 21⁄2 inches deep, and has the spigot inserted 11⁄2 inch into it. The practice of some workmen, is to make the outer faucet, or that which contains the cement, six inches deep, for all pipes above six inches diameter ”
Source: Gutenberg

Get perspective with Kwize: daily news enlightened by great literature